35160 SPIND_EXTERN_VELO_LIMIT A06, A04 A3, S1, V1, Z1
rev/min Spindle speed limitation from PLC DOUBLE NEW CONF
CTEQ
- - 1000.0 1.0e-6 - 2/2
Description: A limiting value for the maximum spindle speed is entered in MD35160
$MA_SPIND_EXTERN_VELO_LIMIT, which is taken into account exactly when the NC/PLC
interface signal DB380x DBX3.6 (Velocity/speed limitation) is set.
The control limits a spindle speed which is too high to this value.
35200 GEAR_STEP_SPEEDCTRL_ACCEL A06, A11, A04 S1
rev/s² Acceleration in speed control mode DOUBLE NEW CONF
CTEQ
- 6 30.0, 30.0, 25.0, 20.0,
15.0, 10.0
1.0e-7 - 1/1
Description: If the spindle is in speed control mode, the acceleration is entered in MD35200
$MA_GEAR_STEP_SPEEDCTRL_ACCEL.
The spindle is in speed control mode with the function SPCOF.
Special cases:
The acceleration in speed control mode (MD35200 $MA_GEAR_STEP_SPEEDCTRL_ACCEL) can be
set so that the electric current limit is reached.
Related to:
MD35210 $MA_GEAR_STEP_POSCTRL_ACCEL(acceleration in position control mode)
MD35220 $MA_ACCEL_REDUCTION_SPEED_POINT (speed limit for reduced acceleration)
35210 GEAR_STEP_POSCTRL_ACCEL A06, A11, A04 S1
rev/s² Acceleration in position control mode DOUBLE NEW CONF
CTEQ
- 6 30.0, 30.0, 25.0, 20.0,
15.0, 10.0
1.0e-7 - 2/2
Description: The acceleration in position control mode must be set so that the electric current
limit is not reached.
Related to:
MD35200 $MA_GEAR_STEP_SPEEDCTRL_ACCEL
MD35212 $MA_GEAR_STEP_POSCTRL_ACCEL2
35212 GEAR_STEP_POSCTRL_ACCEL2 A06, A11, A04 S1
rev/s² 2nd data set: Acceleration in position control mode DOUBLE NEW CONF
CTEQ
- 6 30.0, 30.0, 25.0, 20.0,
15.0, 10.0
1.0e-3 - 1/1
Description: Second gear stage data set for maximum acceleration capability of the gear stages in
position control mode.
The acceleration in position control mode must be set so that the electric current
limit is not reached.
The 2nd data set for tapping with G331/G332 is activated by MD35010
$MA_GEAR_STEP_CHANGE_ENABLE, bit 5 for the master spindle.
Related to:
MD35210 $MA_GEAR_STEP_POSCTRL_ACCEL
MD35200 $MA_GEAR_STEP_SPEEDCTRL_ACCEL
MD35220 $MA_ACCEL_REDUCTION_SPEED_POINT
Machine data
3.4 Axis-specific machine data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 277
To Next Page
Loading...
Need help?
General
