Siemens SINUMERIK 808D ADVANCED

As configuration 0, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
11:
As configuration 1, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
12:
As configuration 2, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
42110 DEFAULT_FEED - V1, FBFA
mm/min Path feed default value DOUBLE Immediately
-
- - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 7/7 U
Description: Default value for path feedrate, This setting data is evaluated when the part program
starts taking into account the feedrate type active at this time (see MD20150
$MC_GCODE_RESET_VALUES and MD20154 $MC_EXTERN_GCODE_RESET_VALUES).
42120 APPROACH_FEED - -
mm/min Path feedrate in approach blocks DOUBLE Immediately
-
808d-me42 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 2/2 M
808d-me62 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 2/2 M
808d-te42 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 2/2 M
808d-te62 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 2/2 M
808d-mte40 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 7/7 U
808d-mte60 - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 7/7 U
Description: Default value for path feedrate in approach blocks (after repos., block search,
SERUPRO etc).
The contents of this settting data are only used when it is non-zero.
It is evaluated like an F word programmed for G94.
42121 AX_ADJUST_FEED - -
mm/min Path feed in adjustment movements DOUBLE Immediately
-
808d-me42 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 2/2 M
808d-me62 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 2/2 M
808d-te42 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 2/2 M
808d-te62 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 2/2 M
808d-mte40 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 7/7 U
808d-mte60 - 0., 0., 0., 0., 0., 0., 0.,
0....
- - 7/7 U
NC setting data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 309