Machine data
2.3 Channel-specific machine data
Parameter Manual
128
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Definition of the effects of tool parameters.
Bit no. meaning when bit is set
----------------------------------------------------------------------------
-
Bit 0: (LSB):
For turning and grinding tools, the wear parameter of the transverse axis is
included in the calculation as a diameter value.
Bit 1:
For turning and grinding tools, the tool length component of the transverse
axis is included in the calculaton as a diameter value.
Bit 2:
If a tool length correction is included in the calculaton as a diameter
value, the tool may only be used in the plane that was active when the tool
was selected. If this bit is set, a plane change leads to an alarm.
Bit 3:
Work offsets in frames in the transverse axis are included in the calculation
as a diameter value.
Bit 4:
PRESET value is included in the calculation as a diameter value
Bit 5:
Include the external work offset in the transverse axis in the calculation as
a diameter value
Bit 6:
Read actual values of the transverse axis as diameter values (AA_IW, AA_IEN,
AA_IBN, AA_IB. Notice: Not AA_IM.)
Bit 7:
Display all actual values of the transverse axis as diameter values, irre-
spective of the G code of group 29 (DIAMON / DIAMOF)
Bit 8:
Always display the distance-to-go as a radius in the work coordinate system
(WCS)
Bit 9:
During DRF handwheel travel of a transverse axis, only half the distance of
the specified increment is traveled (on condition that MD11346
$MN_HANDWH_TRUE_DISTANCE = 1).
Bit10:
Activate the tool component of an active, orientable toolholder even if no
tool is active.
Bit11:
The tool parameter $TC_DP6 is not interpreted as a tool radius but as a tool
diameter.
20360 TOOL_PARAMETER_DEF_MASK C09 M5,P1,W1
- Definition of tool parameters DWORD PowerOn
-
808d-me42 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x1FFFFF 1/1
808d-me62 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x1FFFFF 1/1
808d-te42 - 0x283 0 0x1FFFFF 1/1
808d-te62 - 0x283 0 0x1FFFFF 1/1
To Next Page
Loading...
Need help?
General
