NC setting data
Parameter Manual
302
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
1: Jog mode for JOG continuous
In jog mode (default setting) the axis traverses as long as the traverse key
is held down and an axis limitation has not been reached. When the key is
released the axis is decelerated to zero speed and the movement is considered
complete.
0: Continuous operation for JOG continuous
In continuous operation the traverse movement is started with the first ris-
ing edge of the traverse key and continues to move even after the key is
released. The axis can be stopped again by pressing the traverse key again
(second rising edge).
SD irrelevant for ......
Incremental jogging (JOG INC)
Reference point approach (JOG REF)
41050 JOG_CONT_MODE_LEVELTRIGGRD -H1
- Jog mode / continuous operation with continuous JOG BOOLEAN Immediately
-
- - TRUE 0 - 1/1
To Next Page
Loading...
