Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
303
NC setting data
Description: Bit 0 = 0:
The behavior depends on the following:
- in the case of an axis/spindle:
on the axial SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE
- in the case of a geometry axis with an active frame with rotation:
on the channel-specific SD42600 $SC_JOG_FEED_PER_REV_SOURCE
- in the case of an orientation axis:
on the channel-specific SD42600 $SC_JOG_FEED_PER_REV_SOURCE
Bit 0 = 1:
A JOG motion with revolutional feedrate shall be traversed depending on the
master spindle.
The following must be considered:
- If a spindle is the master spindle itself, it will be traversed without
revolutional feedrate.
- If the master spindle is in stop position and if SD43300
$SA_ASSIGN_FEED_PER_REV_SOURCE (with an axis/spindle) or SD42600
$SC_JOG_FEED_PER_REV_SOURCE (with a geometry axis with an active frame with
rotation, or with an orientation axis) = -3, traversing will be carried out
without revolutional feedrate.
Bit 1 = 0:
The axis/spindle, geometry axis or orientation axis will be traversed with
revolutional feedrate even during rapid traverse (see bit 0 for selection).
Bit 1 = 1:
The axis/spindle, geometry axis or orientation axis is always traversed with-
out revolutional feedback during rapid traverse.
Bit 2 = 0:
The axis/spindle, geometry axis or orientation axis is traversed with revolu-
tional feedrate during JOG handwheel travel, too (see bit 0 for selection).
Bit 2 = 1:
The axis/spindle, geometry axis or orientation axis is always traversed with-
out revolutional feedrate during JOG handwheel travel.
Bit 3 = 0:
The axis/spindle is traversed with revolutional feedrate during DRF handwheel
travel, too (see bit 0 for selection).
Bit 3 = 1:
The axis/spindle is always traversed without revolutional feedrate during DRF
handwheel travel.
41100 JOG_REV_IS_ACTIVE --
- JOG mode: revolutional feedrate / linear feedrate BYTE Immediately
-
- - 0x0E 0 - 1/1
Siemens Controls
To Next Page
Loading...
Need help?
General
