NC setting data
Parameter Manual
304
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Value not equal to 0:
The velocity value entered applies to linear axes traversed in JOG mode if
linear feedrate (G94) is active for the relevant axis (SD41100
$SN_JOG_REV_IS_ACTIVE = 0).
The axis velocity is active for
• continuous jogging
• incremental jogging (INC1, ... INCvar)
• handwheel traversing.
The value entered is valid for all linear axes and must not exceed the maxi-
mum permissible axis velocity (MD32000 $MA_MAX_AX_VELO).
In the case of DRF, the velocity defined by SD41110 $SN_JOG_SET_VELO is
reduced by
MD32090 $MA_HANDWH_VELO_OVERLAY_FACTOR.
Value = 0:
If 0 has been entered in the setting data, the active linear feedrate in JOG
mode is
MD32020 $MA_JOG_VELO "Jog axis velocity". Each axis can be given its own JOG
velocity with this MD (axial MD).
SD irrelevant for ......
• Linear axes if SD41100 $SN_JOG_REV_IS_ACTIVE = 1
• Rotary axes (SD41130 $SN_JOG_ROT_AX_SET_VELO is active here)
Application example(s)
The operator can thus define a JOG velocity for a specific application.
Related to ....
SD41100 $SN_JOG_REV_IS_ACTIVE (revolutional feedrate with JOG active)
Axial MD32020 $MA_JOG_VELO (JOG axis velocity)
Axial MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
Axial MD32090 $MA_HANDWH_VELO_OVERLAY_FACTOR (ratio of JOG velocity to hand-
wheel velocity (DRF))
SD41130 $SN_JOG_ROT_AX_SET_VELO (JOG speed with rotary axes)
41110 JOG_SET_VELO -H1
mm/min Axis velocity in JOG DOUBLE Immediately
-
-- 0.0 0.0 - 7/7
To Next Page
Loading...
