Detailed descriptions of interface signals
4.8 Axis / spindle-specific signals
Parameter Manual
376
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
4.8 Axis / spindle-specific signals
Figure 4-2 PLC interface signals for axis monitoring
DB3500
DBB0 - 63
Active G function of groups 1 to 64
Signal(s) from channel (NCK → PLC)
Edge evaluation: No Signal(s) updated: Event-controlled
Signal status > 1 A G function of the G group is active.
The active G group is saved in the dual format in the byte involved, e.g. G90:
0 1 0 1 1 0 1 0
Signal state 0 No G function of the G group is active.
Special cases, errors,
...
In contrast to auxiliary functions, G functions are not output to the PLC
subject to acknowledgement, i.e. processing of the part program is continued
immediately after the G function output.
Note for the reader Programming Manual, Fundamentals
6LJQDOVWRD[LV'%[
[ !$[LV
[ !$[LV
6LJQDOVIURPD[LV'%[
[ !$[LV
[ !$[LV
&ODPSLQJLQSURJUHVV'%['%;
+DUGZDUHOLPLWVZLWFKSOXV'%['%;
+DUGZDUHOLPLWVZLWFKPLQXV'%['%;
QGVRIWZDUHOLPLWVZLWFKSOXV'%['%;
QGVRIWZDUHOLPLWVZLWFKPLQXV'%['%;
$[LV
$[LV
$[LV
$[LVPRQLWRULQJ
IXQFWLRQV
(QFRGHUIUHTXHQF\
RYHUOLPLWHG
'%['%;
To Next Page
Loading...
Need help?
General
