Siemens SINUMERIK 808D ADVANCED

Machine data
2.4 Axis-specific machine data
Parameter Manual
192 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
2.4 Axis-specific machine data
Description: Description
Description: In this MD, enter the number of the bus segment through which the output is
addressed.
0: Local bus (808d, 828d analog spindle)
1: reserved (previously SIMODRIVE611D bus, 1st DCM)
2: reserved (previously local P bus)
3: reserved (previously SIMODRIVE611D-Bus, 2. DCM)
4: reserved (virtual buses)
5: PROFIBUS/PROFINET (e.g. SINUMERIK 840Di)
6: reserved (same effect as 5)
Description: Enter in this MD the number of the module within a bus segment through which
the output is addressed.
For axes on the PROFIBUS/PROFINET, the number of the drive assigned with
MD13050 $MN_DRIVE_LOGIC_ADDRESS must be entered here (MD30110
$MA_CTRLOUT_MODULE_NR=n consequently points to MD13050
$MN_DRIVE_LOGIC_ADDRESS[n]).
Description: Number of the output on a module which is used to address the setpoint out-
put.
The value is always 1 for modular drives.
Number Identifier Display filters Reference
Unit Name Data type Active
Attributes
System Dimension
Default value
(LIN/ROT)
Minimum
value
(LIN/ROT)
Maximum
value
(LIN/ROT)
Protection
30100 CTRLOUT_SEGMENT_NR EXP, A01 G2,S9
- Setpoint assignment: bus segment number BYTE PowerOn
-
808d-me42 1 0 0 0 -1/2
808d-me62 1 5 0 5 2/2
808d-te42 1 0 0 0 -1/2
808d-te62 1 5 0 5 2/2
30110 CTRLOUT_MODULE_NR A01, A11, - G2,S9
- Setpoint assignment: module number BYTE PowerOn
-
- 1 1, 2, 3, 4, 5, 6, 7, 8... 1 31 2/2
30120 CTRLOUT_NR EXP, A01, - G2
- Setpoint assignment: Setpoint output on drive submodule/
module
BYTE PowerOn
-
808d-me42 1 1, 2, 3, 4 1, 1, 1, 1 4, 4, 4, 4 2/2
808d-me62 1 1, 1, 1, 1, 1, 1, 1, 1... 1 4 2/2
808d-te42 1 1, 2, 3, 4 1, 1, 1, 1 4, 4, 4, 4 2/2
808d-te62 1 1, 1, 1, 1, 1, 1, 1, 1... 1 4 2/2