Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
447
PLC User Interface
5.9 Axis/spindle signals
5.9 Axis/spindle signals
5.9.1 Transferred M and S functions, axis specific
5.9.2 Signals to axis/spindle
Common signals to axis/spindle
DB3700 … 3703 M, S functions [r]
NCK -> PLC interface
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 M function for spindle (DINT)
4 S function for spindle (REAL)
DB3800 ...
3803
Signals to axis/spindle [r/w]
PLC -> NCK interface
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Feedrate override
HGFEDCBA
1 Override
active
Position
measuring
system 2
Position
measuring
system 1
Follow up
mode
Axis spindle
disable
2 Reference point value Clamping in
progress
Distance-
to-go/
spindle
reset
Controller
enable
4321
3 Axis/spindle
enable
program
test
Velocity/
spindle
speed
limiting
Activate fixed feedrate Enable
approach to
fixed stop
Feed 4 Feed 3 Feed 2 Feed 1
4 Traversing keys Rapid
traverse
override
Traverse
key disable
Feedrate
stop/spindle
stop
Activate handwheel
Plus Minus 2 1
5
Machine function
1)
Continuous
traversing
Var. INC 1000 INC 1000 INC 100 INC 10 INC 1 INC
6
1)
The machine function is only entered if the signal "INC inputs in the operating-mode signal range active" (DB2600.DBX1.0)
is set.
Siemens Controls
To Next Page
Loading...
