Machine data
2.3 Channel-specific machine data
Parameter Manual
130
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
This machine data determines in ISO dialect M (G43 / G44) the way in which
length compensations programmed with H are processed.
0: Mode A
Tool length H always acts on the third geometry axis (usually Z)
1: Mode B
Tool length H acts, depending on the active plane, on one of the three geom-
etry axes. This means with
G17 on the 3rd geometry axis (usually Z)
G18 on the 2nd geometry axis (usually Y)
G19 on the 1st geometry axis (usually X)
In this mode, compensations in all three geometry axes can be configured
through multiple programming, i.e. through the activation of one component,
the length compensation possibly active in another axis is not deleted.
2: Mode C
The tool length acts, independent of the active plane, on the axis that has
simultaneously been programmed with H. Otherwise, the response is the same as
with mode B.
Description: This machine data determines how the tool length compensations are traversed.
0: A tool length compensation is only traversed if the associated axis has
been programmed (behavior as in previous software versions)
1: Tool lengths are always traversed independently of whether the associ-
ated axes are programmed or not.
Description: This machine data determines for tool length compensation in ISO dialect M
(ISO2) (G43 / G44), whether the compensation shall be allowed in mode C
(selection of the axis on which the compensation is acting by specifying the
corresponding axis letter) to act on several axes simultaneously.
If this machine data is 1, this type of programming is allowed; otherwise it
is rejected with an alarm.
20380 TOOL_CORR_MODE_G43G44 C01, C08, C11 -
- Treatment of tool length compensation with G43 / G44 BYTE Reset
-
808d-me42 - 1 0 2 2/2
808d-me62 - 1 0 2 2/2
808d-te42 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2
808d-te62 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2
20382 TOOL_CORR_MOVE_MODE C01, C08 -
- Traversing of tool length compensation BOOLEAN Reset
-
- - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 1/1
20384 TOOL_CORR_MULTIPLE_AXES C01, C08, C11 -
- Tool length compensation in several axes simultaneously BOOLEAN Reset
-
- - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE...
0 - 1/1
To Next Page
Loading...
Need help?
General
