Machine data
2.4 Axis-specific machine data
Parameter Manual
240
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
1: LEC (leadscrew error compensation) is activated for the measuring system.
This enables leadscrew and measuring system errors to be compensated.
The function is not enabled internally until the relevant measuring system
has been referenced (NC/PLC interface signal DB390x DBX0.4 / .5 (Referenced/
synchronized 1 or 2) = 1).
write protect function (compensation values) active.
0: LEC is not active for the axis/measuring system.
Related to:
MD38000 $MA_MM_ENC_COMP_MAX_POINTS number of interpolation points with LEC
NC/PLC interface signal DB390x DBX0.4 (Referenced/synchronized 1)
NC/PLC interface signal DB390x DBX0.5 (Referenced/synchronized 2)
Description: 1: Sag compensation is enabled for this axis.
Inter-axis machine geometry errors (e.g. sag and angularity errors) can be
compensated with sag compensation.
The function is not activated until the following conditions have been ful-
filled:
• The "Interpolatory compensation" option is set
• The associated compensation tables have been loaded into the NC user mem-
ory and enabled (SD41300 $SN_CEC_TABLE_ENABLE[t] = 1)
• The relevant position measuring system is referenced (NC/PLC interface
signal DB390x DBX0.4 / .5 = 1 (Referenced/synchronized 1 or 2)):
0: Sag compensation is not enabled for the compensation axis.
Related to:
MD18342 $MN_MM_CEC_MAX_POINTS[t]
Number of interpolation points for sag compensation
SD41300 $SN_CEC_TABLE_ENABLE[t]
Enable evaluation of sag compensation table t
NC/PLC interface signal DB390x DBX0.4 / .5
(referenced/synchronized 1 or 2)
Description: Compensation data exist in:
0: inch system
1: metric system
32700 ENC_COMP_ENABLE A09 K3
- Encoder/spindle error compensation. BOOLEAN NEW CONF
-
- 1 FALSE, FALSE 0 - 2/2
32710 CEC_ENABLE A09 K3
- Enable of sag compensation BOOLEAN NEW CONF
-
-- FALSE0 - 1/1
32711 CEC_SCALING_SYSTEM_METRIC A09 K3,G2
- Measuring system of sag compensation BOOLEAN NEW CONF
-
- - TRUE 0 - 1/1
To Next Page
Loading...
Need help?
General
