NC setting data
Parameter Manual
318
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
This setting data is used to define the circle center point in the workpiece
coordinate system during JOG of circles.
Only the relevant center point coordinates of the geometry axes in the active
plane are evaluated, not the coordinate of the geometry axis vertical to the
plane. This setting data is written via the user interface.
By default the coordinate of an axis with diameter programming is in the
diameter. This can be changed with MD20360 $MC_TOOL_PARAMETER_DEF_MASK Bit 13
= 1 by indicating a radius.
Description: With this setting data, the circle radius in the machine, the maximum circle
during inner machining or the minimum circle during outer machining are
defined when jogging circles. This setting data is written via the user
interface.
42690 JOG_CIRCLE_CENTRE --
mm Center of the circle DOUBLE Immediately
-
- 3 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 2/2
42691 JOG_CIRCLE_RADIUS --
mm Circle radius DOUBLE Immediately
-
- - 0, 0, 0, 0, 0, 0, 0, 0... - - 2/2
To Next Page
Loading...
