NC setting data
Parameter Manual
320
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
This setting data defines the end angle during JOG of circles.
The end angle refers to the abscissa of the current plane. Traversing is only
possible within the range
between the start and the end angle. SD42692 $SC_JOG_CIRCLE_MODE bit 0
defines the direction from the start to the end angle. If start and end angle
equal zero, no limitation is active.
This setting data is written via the user interface.
Description: Value 0: Disable basic blocks with absolute values (basic block display)
Value 1: Enable basic blocks with absolute values (basic block display)
42694 JOG_CIRCLE_END_ANGLE --
degrees Circle end angle DOUBLE Immediately
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 360 2/2
42750 ABSBLOCK_ENABLE -K1
- Enable base block display BOOLEAN Immediately
-
- - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE...
0 - 1/1
To Next Page
Loading...
