Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
327
NC setting data
Description: Spindle position in [ DEGREES ] for spindle positioning with M19.
The position approach mode is defined in SD43250 $SA_M19_SPOSMODE.
Default positions must lie in the range 0 <= pos < MD30330 $MA_MODULO_RANGE.
Path defaults (SD43250 $SA_M19_SPOSMODE = 2) can be positive or negative and
are only limited by the input format.
Description: Spindle position approach mode for spindle positioning with M19.
In which signify:
0: DC (default) approach position on the shortest path.
1: AC approach position normally.
2: IC approach incrementally (as path), sign gives the traversing direc-
tion
3: DC approach position on the shortest path.
4: ACP approach position from the positive direction.
5: ACN approach position from the negative direction.
Description: 0= No revolutional feedrate is active.
>0= Machine axis index of the rotary axis/spindle, from which the revolu-
tional feedrate is derived.
-1= The revolutional feedrate is derived from the master spindle of the
channel in which the axis/spindle is active
-3= The revolutional feedrate is derived from the master spindle of the
channel in which the axis/spindle is active. No revolutional feedrate is
active if the master spindle is at a standstill.
Related to ....
SD42600 $SC_JOG_FEED_PER_REV_SOURCE (revolutional feedrate for geometry
axes on which a frame with rotation acts in JOG mode.)
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
Description: Position to be approached in JOG. Depending on MD10735 $MN_JOG_MODE_MASK bit
4 axial frames and, with an axis configured as geometry axis, the tool length
offset are considered.
43240 M19_SPOS -, A12 S1
degrees Spindle position for spindle positioning with M19. DOUBLE Immediately
-
- - 0.0 -10000000.0 10000000.0 7/7
43250 M19_SPOSMODE -, A12 S1
- Spindle position approach mode for spindle positioning with
M19.
DWORD Immediately
-
-- 0 0 5 7/7
43300 ASSIGN_FEED_PER_REV_SOURCE -V1,P2,S1
- Revolutional feedrate for positioning axes/spindles DWORD Immediately
CTEQ
- - 0 -3 31 1/1
43320 JOG_POSITION --
mm, degrees JOG position DOUBLE Immediately
-
-- 0.0 - - 7/7
Siemens Controls
To Next Page
Loading...
