Siemens SINUMERIK 808D ADVANCED

Machine data
2.2 General machine data
Parameter Manual
64 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Only values of the selected file of the active file system
that deviate from the default setting are backed up.
TRUE = only the values of the selected file of the active file system that
deviate from the standard setting are backed up (a differential data backup)
The value of MD11210 $MN_UPLOAD_MD_CHANGES_ONLY than has no effect.
FALSE = all values of the selected file of the active file system are backed
up.
Same significance as MD11210 $MN_UPLOAD_MD_CHANGES_ONLY=0.
However, if MD11210 $MN_UPLOAD_MD_CHANGES_ONLY is not equal to 0,
then this setting is active.
Description: Number of the system data block (SDB) used for configuring the I/Os.
Description: Configuration of the tracefiles SIEM*
Bit0:
Additional information about the PDUs sent is to be entered in
_N_SIEMDOMAINSEQ_MPF for download
Bit1:
Additional information about the PDUs received is to be entered in
_N_SIEMDOMAINSEQ_MPF for download
Bit2:
Trace of warm start and connection cancelation in_N_SIEMDOMAINSEQ_MPF
Bit4:
Additional information about the PDUs sent is to be entered in
_N_SIEMDOMAINSEQ_MPF for upload
Bit5:
Additional information about the PDUs received is to be entered in
_N_SIEMDOMAINSEQ_MPF for upload
11212 UPLOAD_CHANGES_ONLY N01, N05 IAD
- Data backup type for an active file system. BOOLEAN Immediately
-
- - TRUE - - 2/2
11240 PROFIBUS_SDB_NUMBER N01, N05 K4,FBU
- SDB number DWORD PowerOn
-
808d-me42 4 -1, -1, -1, -1 -1 7 -1/2
808d-me62 4 0, -1, -1, -1 -1 7 2/2
808d-te42 4 -1, -1, -1, -1 -1 7 -1/2
808d-te62 4 0, -1, -1, -1 -1 7 2/2
11294 SIEM_TRACEFILES_CONFIG EXP -
- Configuration of the SIEM* trace file DWORD PowerOn
-
-- 0 0 - 1/1