04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–106
SINUMERIK 840C / SIMODRIVE 611–D (DA)
105042 Incorrect reference to dialog description for no. ... Acknowledgement key
Power up
Reference set to the first dialog description.
Error during conversion of ASCII files. A message has a reference to a dialog description greater than or equal to
the number of dialog descriptions.
Eliminate error in the alarm configuration
SW 5 and higher
105043 Message no. ... neither dialog nor message Acknowledgement key
Power up
Value 0 understood.
Error during conversion of ASCII files. The third from last parameter of the message description is not 0 or 1 (0 for
message line, 1 for dialog box)
Eliminate error in the alarm configuration.
SW 5 and higher
105044 Syntax error in message configuration Acknowledgement key
Power up
Binary files have been read from the Siemens branch.
Error during conversion of ASCII files. The converter could not interpret the message attribute/message text files.
The binary files from the Siemens branch have been read in.
Eliminate error in the alarm configuration.
SW 5 and higher
105045 No communication to PLC
Permanently
MMC cannot communicate with PLC
Communication with PLC aborted after an error or time overrun
Check whether module is slotted in, notify Service.
105046 PLC failed with error ...
Permanently
If the PLC signals an error, the error number is entered in the alarm log
Used for logging the PLC error number
Report error no. to Siemens, log module
105047 PLC Reset – please wait ...
Permanently
No communication possible with PLC at the moment
This alarm is displayed while communication is started, e.g. after a link bus reset. It dissappears after a short time
Wait
105048 Text in ... not available
After Power On
A language which is not available has been set in the config file in the master control
Siemens settings apply
Set correct language and Power On
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
08/96
To Next Page
Loading...
