04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–179
SINUMERIK 840C / SIMODRIVE 611–D (DA)
165077 Pole pair no. (ratio MD x130/MD x400) illegal OK softkey
Softkey ”Calculate controller data (MSD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The pole pair no. (ratio rated frequency (MD 1134 and MD 2134) / rated speed (MD 1400 and MD 2400) is illegal.
If necessary, correct value and repeat function.
Applies as from SW 5.4
165078 MIC %1
In the machine data dialog (MDD) when softkey ”Start conversion” is pressed
The target data record is not created.
An error (e.g. syntax error) has occurred in the configuration file that belongs to the metric/inch conversion. The
error message contains a line number and a description of the cause of the error or only a general error text that
cannot be assigned to a specific line number.
Eliminate the error in the configuration file (see conversion data in file CONFIG).
Alarm from SW 6.3
300000 System error POWER ON
Cyclic after control startup
Machining stops, interlocking of NC Start and Mode Group Ready
Additional
information 1
(error no.)
Additional
information 2
Explanation Remedy
To Next Page
Loading...
Need help?
General
