Siemens SINUMERIK 840C - Page 132

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–124
SINUMERIK 840C / SIMODRIVE 611–D (DA)
120007 No data presetting possible OK softkey
Standard default setting could not be set.
SIEMENS default setting is used.
–
Check path setting of data selector in SIIEMENS branch; the path must also exist in the user branch.
120008 No data storage possible here OK softkey
No NC/PPLC data can be stored in the SIEMENS area.
None
Only data transfer from the NCK in the user areas of the MMC is possible.
Select user area.
120009 Password incorrect OK softkey
An incorrect password has been entered.
See alarm message 120003 “No password set”
None
Enter correct password, press “Return” key and the “Set” softkey.
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description