Siemens SINUMERIK 840C - Page 141

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–133
SINUMERIK 840C / SIMODRIVE 611–D (DA)
142007 ”Error on loading the TOA data !”
142008 ”Error on loading the SEA data !”
142009 ”No operational data, default setting !”
142010 ”No machined parts available !”
142011 ”Too many points in contour %1 !”
142015 ”Error on storing operational data !”
142020 ”Error on loading the TOA data !”
142021 ”Error on loading the TOA data !”
142022 ”No D number in tool list !”
142025 ”Programm %1 does not exist !”
142026 ”Syntax error in job list !”
142027 ”Job list could not be evaluated”
142030 ”Axis in transmit data set not defined”
142031 ”Axis in transmit data expected to be fictit.”
142032 ”Axis in transmit data set expected to be real”
142033 ”Axis in transmit data set exists several times”
142034 ”Non–assigned transmit MD incorrectly initialized”
142035 ”No data set exists for TRANSMIT !”
143000 ”Access via P address does not exist !”
143001 ”Pointer in P cell invalid !”
143002 ”R parameter address invalid on READING !”
143003 ”R parameter address invalid on WRITING !”
143004 ”TO area not available !”
143005 ”There is no D compensation memory !”
143006 ”No access to settable zero offset”
143007 ”No access to progr. zero offset”
143008 ”Specified angle No. not equal to 1 !”
143009 ”No access to settable coordinate rotation”
143010 ”No access to progr. coordinate rotation”
144051 ”Circle end point error in circle programming”
144052 ”Full circle with circle rad.prog. not allowed”
144053 ”Radius too small for programmed circle”
144100 ”Wrong input for contour definition !”
144101 ”No intersection possible !”
144102 ”Angle value not allowed !”
144103 ”Radius value not allowed !”
1 Alarms
1.5.1 Alarm description