Siemens SINUMERIK 840C - Page 148

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–140
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146255 ”Spline interpolation G06 cannot be simulated”
146256 ”Spline interpolation G06 cannot be simulated”
146261 ”In–process measurement @720 is not simulated”
146262 ”Program coord. [...] not being simulated”
146263 ”Coupled motion is not simulated”
146264 ”G200 will not be simulated”
146265 ”G103 is not simulated”
146266 ”G104 is not simulated”
146267 ”G105 is not simulated”
146268 ”G119 is not simulated”
146269 ”G24 is not simulated ”
146271 ”Ramp–up time G92 T is not simulated”
146272 ”Starting angle offset G92 A is not simulated”
146273 ”Working area limitation G25 is not simulated”
146274 ”Working area limitation G26 is not simulated”
146275 ”M36/M37 is not simulated”
146276 ”Exact stop G60 is not simulated”
146277 ”Velocity reduction G62 is not simulated”
146278 ”Velocity reduction G64 is not simulated”
146290 ”Context: measurement function @720”
146291 ”Context: G function of 7th group”
146292 ”Context: scale modification G51”
146293 ”Context: synchronized spindle stop M19S”
146294 ”Context: program jump”
146295 ”Context: block to be skipped”
146296 ”Context: dwell”
146297 ”Context: refpt preprocess f. stock rem. cycle”
146298 ”Context: intersection calc.f.stock rem. cycle”
146299 ”Context: plane selection with free axis sel.”
146300 ”Context: cylindrical interpolation G92P”
146301 ”Context: transfomation”
146302 ”Context: approach reference point”
146303 ”Context: pole specification”
146304 ”Context: spline interpolation is selected”
146305 ”Context: block preprocessing stop by @714”
146307 ”Context: G200 block”
1 Alarms
1.5.1 Alarm description