04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–189
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Error No.
F...
Additional
information
(xx = for diagno-
stic purposes)
Explanation Remedy Relevant for
F030 Error code / Axis
No.
0x01; non–sup-
ported ROSCTR
0x02; illegal
ROSCTR
0x03; job man-
agement ”defec-
tive”
0x04; wrong
PDUREF for ac-
knowledgement
0x05; acknowl-
edgement illegal
at that time
0x06; acknowl-
edgement is not
supported
0x07; illegal
PROTID
0x08; illegal
PERLG (odd)
0x09; buffer man-
agement ”defec-
tive”
0x0A; illegal PI
code (internal)
0x0B; internal
status of PI re-
start illegal
0x0C; status pro-
cessor in WRITE-
DATA ”defective”
0x0D; illegal
transmission pa-
rameter for RE-
FRESH_PI ZUST
NC drive number
Either irrecoverable errors have
been found in the communication
via the drive bus, or the drive soft-
ware is no longer consistent. Cause
is either a defective drive bus inter-
face or a hardware fault on the
servo control group.
Check drive bus cable and plug-on
connectors, take measures to elimi-
nate noise (screening, check
ground connections), replace servo
control module.
FDD / MSD
F032 Error code / Axis
No.
0x20; job man-
agement ”defec-
tive”
0x21; illegal sta-
tus in
SET_TRANSPO
0x22; checksum
test incorrect
more than 3
times
0x23; receive
PDU too long
0x24; status 6XX
abort illegal NC
drive number
Either irrecoverable errors have
been found in the communication
via the drive bus, or the drive soft-
ware is no longer consistent. Cause
is either a defective drive bus inter-
face or a hardware fault on the
servo control group.
Check drive bus cable and plug-on
connectors, take measures to elimi-
nate noise (screening, check
ground connections), replace servo
control module.
FDD / MSD
F040 xx / xx An illegal number of current setpoint
filters (>4) has been entered.
Correct number of current setpoint
filters MD1200.
FDD / MSD
F041 xx / xx An illegal number of speed setpoint
filters (>2) has been entered.
Correct number of speed setpoint
filters MD1500.
FDD / MSD
1 Alarms
1.5.1 Alarm description
07/97
To Next Page
Loading...
Need help?
General
