04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–32
SINUMERIK 840C / SIMODRIVE 611–D (DA)
2060 Programming error with TO or ZO Reset key
When executing a part program
S Machining is interrupted
S Interlocking of NC START
S Tool type is 0 (i.e. no tool)
S A tool offset number which is not present has been selected
S The values in the zero offsets or tool offsets selected are too large
S Check and correct specifications of tool offsets and zero offsets
S Check and correct program
Alarm is displayed with reference to block and channel
2061 General programming error Reset key
When executing a part program
S Machining is stopped or is not started
S Interlocking of NC START
S The programmed distance to go has exceeded the permissible distance to go. This is dependent on the input
resolution, for example.
S G63 was not programmed together with G01 (G63 has no effect with G0).
S An axis for which mirroring is active has been programmed with G220 or @736.
S A thread block has been programmed with thread lead 0 or distance to go 0.
S G02/G03 has been programmed together with G63.
S The residual path of an axis in the thread block is 0 after block search with calculation.
S Check the program part and correct the incorrect setting
S Check the input resolution selected
Alarm is displayed with reference to block and channel
2062 Feed is missing Reset key
When executing a part program
S Machining stops
S Interlocking of NC START
S Revolutional feedrate G95 greater than 50 mm/min. has been programmed
S No revolutional feedrate has been programmed
S No feedrate value (F value) has been programmed
S Feedrate is missing for soft approach and retraction
S Setting in machine data MD 280* for max. speed of an axis has been given the value 0
S Check settings in program block
S Check machine data settings
S Cancel alarm using RESET key
Alarm is displayed with reference to block and channel
2063 Thread pitch too large Reset key
When thread cutting with G33
S Machining stops
S Interlocking of NC START
S The thread lead can be specified in the program under I, J or K. The programmed set value exceeds the
permissible value depending on the preset display resolution.
S Correct program block whose block number and channel number are specified in the alarm display
S Cancel alarm using RESET
Alarm is displayed with reference to block and channel
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
01/99
To Next Page
Loading...
Need help?
General
