Siemens SINUMERIK 840C Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–34
SINUMERIK 840C / SIMODRIVE 611–D (DA)
2069 5D tool length comp. not possible Reset key
When executing a part program
S Machining is interrupted or not performed
S Interlocking of NC START
S Cutter radius compensation has been selected
S No linear interpolation has been selected
S Function is not enabled
S Machine data have been entered incorrectly
S Export version
S Check program
S Check machine data
Alarm is displayed with reference to block and channel
2070 5D interpolation missing Reset key
When executing a part program
S Machine stops
S Interlocking of NC START
More than three axes have been programmed in one block in a program, or a function has been selected which
may result in additional axes from the programming, e.g. when specifying the coordinate rotation.
S Check program
S Have function option retrofitted if possible
Alarm is displayed with reference to block and channel
2072 Wrong input value contour definition Reset key
When working in AUTOMATIC or MDA
S Machining is not performed or is terminated
S Interlocking of NC START
When programming, an input which cannot be calculated was specified for contour definition calculation.
S Check program and correct input values
S Cancel alarm using “RESET”
Alarm is displayed with reference to block and channel
2073 No intersection contour definition Reset key
When working in AUTOMATIC
S Machining is not performed or is terminated
S Interlocking of NC START
In calculating the contour definition with the programmed values, no intersection results.
S Check program settings
S Cancel alarm using “RESET”
Alarm is displayed with reference to block and channel
2074 Wrong angle value contour definition Reset key
When working in AUTOMATIC or MDA
S Interlocking of NC START
S Machining stops
S Angle > or = 360 degrees has been programmed
S Value of angle for the contour described is meaningless
S Check and correct program settings
S Cancel alarm using “RESET”
Alarm is displayed with reference to block and channel
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
07/97

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English