Siemens SINUMERIK 840C Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–74
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1300* Progr. axis is not a rotary axis CANCEL
When executing AUTOMATIC, MDA and TEACH IN
S Interlocking of NC START
S Machining stop
G[...]103, G[...]104, G[...]105, G[...]119, G195, G295 not programmed in connection with a rotary axis.
Correct the block!
Applies as from SW 4; alarm is channel-specific and block-specific!
1304* Axis turning endlessly Reset key
On block search with calculation
S Cancellation of the block search
An endlessly rotating rotary axis is programmed as contouring axis although the axis is still rotating endlessly.
Stop the endlessly rotating rotary axis and start the block search again.
Applies as from SW 4; alarm is channel-specific and block-specific!
1308* Error in progr. of sim. axis Reset key
When executing a part program
S Machining abort
The “Endlessly rotating rotary axis” is programmed with G[..]119P[..].. without the endless rotation being switched
on.
Correct the block!
Applies as from SW 4; alarm is channel-specific and block-specific!
1312* Error in progr. of sim. axis CANCEL
When executing a part program
S Machining abort
The “Endlessly rotating rotary axis” has been incorrectly programmed.
Correct the block!
Applies as from SW 4; alarm is channel-specific and block-specific!
1316* Programmed position behind SW limit switch Reset key
When executing a part program
Processing stops at indicated block.
The programmed end point of the displayed axis (incl. the active offsets) lies behind the software limit switch.
S Correct program
S Check MD “1st and 2nd software limit switch plus/minus”
S Check PLC interface signal “2nd software limit switch active”
Alarm is displayed axis-specifically, for the block and channel in question.
Alarm applies as from SW 5
1320* Axis not in C axis mode CANCEL
When traversing a C axis that is in spindle mode.
Axis is not traversed.
A C axis has been programmed in spindle mode.
The alarm is only output if MD 5025.5 is set.
Switch C axis to C axis mode.
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
07/9707/97

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English