EasyManuals Logo

Siemens SIPART PS2 Service Manual

Siemens SIPART PS2
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Introduction
1.7 Loss of degree of protection
PS2 Troubleshooting Guide
Service Manual, 03/2017, A5E36661550-AA
7
1.7
Loss of degree of protection
Note
Loss of degree of protection
Damage to device if the enclosure is o
pen or not properly closed. The degree of protection
specified on the nameplate or in Chapter "Technical data" in Operating Instructions
A5E00074631 is no longer guaranteed.
Make sure that the device is securely closed.
1.8
Commissioning and operation with error message
WARNING
Commissioning and operation with pending error
If an error message appears, correct operation in the process is no longer guaranteed.
Check the gravity of the error.
Correct the error.
If the error still exists:
Take the device out of operation.
Prevent renewed commissioning.
1.9
Basic safety instructions
Qualified personnel for hazardous area applications
Persons who install, connect, commission, operate, and service the device in a hazardous
area must have the following specific qualifications:
They are authorized, trained or instructed in operating and maintaining devices and
systems according to the safety regulations for electrical circuits, high pressures,
aggressive, and hazardous media.
They are authorized, trained, or instructed in carrying out work on electrical circuits for
hazardous systems.
They are trained or instructed in maintenance and use of appropriate safety equipment
according to the pertinent safety regulations.

Table of Contents

Other manuals for Siemens SIPART PS2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIPART PS2 and is the answer not in the manual?

Siemens SIPART PS2 Specifications

General IconGeneral
Supply Pressure1.4 to 7 bar (20 to 100 psi)
Enclosure RatingIP66/NEMA 4X
Communication ProtocolsHART, PROFIBUS PA, FOUNDATION Fieldbus
Output Pressure0 to 100% of supply pressure
Hazardous Area CertificationATEX, IECEx, FM, CSA
TypeElectropneumatic
Input Signal4-20 mA
Rotation Angle30° to 90°
Operating Temperature-40°C to +80°C
MountingLinear and rotary actuators
Air ConsumptionTypically less than 0.1 kg/h

Related product manuals