Siemens SIPROTEC PROFINET IO

2 PROFINET IO in SIPROTEC
2.1 Identification of Module and Firmware
19SIPROTEC 4, Communication Module PROFINET IO, Communication Profile
C53000-L1840-C360-1, Edition 08.2012
Labeling of the PROFINET module
The EN100 modules with PROFINET IO on the rear panel of the SIPROTEC device are labeled as follows:
Figure 2-3 Labeling EN100-E+ with PROFINET IO
Figure 2-4 Labeling EN100-O+ with PROFINET IO
Meaning of the labeling:
• X1: PROFINET IO interface
• X1 P1: PROFINET IO port 1 (identification as "port-001" via LLDP and SNMP)
• X1 P2: PROFINET IO port 2 (identification as "port-002" via LLDP and SNMP)
com_profinet-io_profile_us.book Page 19 Friday, August 17, 2012 1:40 PM