Siemens SIPROTEC PROFINET IO User Manual

4 PROFINET IO Diagnosis
4.3 I&M - Identification and Maintenance
93SIPROTEC 4, Communication Module PROFINET IO, Communication Profile
C53000-L1840-C360-1, Edition 08.2012
4.3 I&M − Identification and Maintenance
The PROFINET IO implementation in SIPROTEC devices supports reading of I&M0 data plus reading and
writing of I&M1, I&M2, I&M3 and I&M4 data.
The I&M0 data have the following content:
Table 4-3 Content of I&M0 Data
Name Content
VendorID = 0x002A (PROFINET vendor ID of Siemens AG)
OrderID Order number (MLFB) of the PROFINET IO EN100 module
SerialNumber Serial number of the EN100 module
HardwareRevision Hardware version of the EN100 module
SWRevision.Prefix = ‘V’ (officially released version)
SWRevision.FunctionalEnhancement Software version of the PROFINET IO firmware:
<FunctionalEnhancement>.<BugFix>.<InternalChange>
for example 01.00.00
SWRevision.BugFix
SWRevision.InternalChange
NOTE
The order number (MLFB) and the serial number of the SIPROTEC device are shown, for example, on the
EN100 homepage in the "Startup log" (see Figure 4-1).
com_profinet-io_profile_us.book Page 93 Friday, August 17, 2012 1:40 PM

Siemens SIPROTEC PROFINET IO Specifications

General

Brand	Siemens
Model	SIPROTEC PROFINET IO
Category	Control Unit
Language	English