Operation
106
Siemens Building Technologies
Fire Safety & Security Products 03.2007
You can use other functions on the DVR while video is being backed up. To do
this, highlight the Close button and press the
button. You can return to the Clip-
Copy screen at any time to check the progress.
Refer to the Appendix, Section 12.2: Reviewing video clips for instructions on how
to review video clips you have copied.
NOTE
During Clip Copy, you cannot shut the system down, clear data on the storage device, or format the
storage device.
NOTE
Do not disconnect the USB cable or the power from the external drive while copying video clips. If the
external drive is shut down or the USB cable is disconnected while copying video clips, THE DVR
SYSTEM MAY NOT WORK NORMALLY OR THE EXTERNAL DRIVE COULD BE DAMAGED, and
you will get an error message the next time you try to copy video clips. You will need to power down
the DVR and restart it to get rid of the error message. Once the file system of the USB-IDE hard disk
drive has been corrupted, this error message cannot be dismissed. Even after restarting the DVR it
may automatically restart while preparing to clip copy. You must recover the file system using the
recovery program, or you must reformat the hard disk drive.
9.10.7 Print screen
You can print images from the screen. Connect a PostScript™ printer to one of the
USB ports. A message appears asking you if you want to print the current image.
Fig. 119 Print screen
NOTE
If your printer only supports an LPT connection (parallel), use an LPT to USB converter cable. The
printer cable is not provided.
To Next Page
Loading...
Need help?
General
