Configuration
75
Siemens Building Technologies
Fire Safety & Security Products 03.2007
8.10.2 Storage Status screen
Highlight Storage Status in the Storage menu and press the button.
Î The Storage Status setup screen appears and displays information about the
DVR’s storage devices.
Fig. 84 Storage Status screen
The Type column displays the type of storage device.
The Disk Bad column displays the percentage of bad sectors. "Not formatted"
indicates the device is not formatted.
The Temperature column displays the temperature of the storage device.
The S.M.A.R.T. column displays “Good”, “Bad” or “N/A”, depending on storage
conditions:
Good The storage condition is normal.
Bad Data cannot be written on or read from the storage device.
N/A Storage conditions are normal, however, the S.M.A.R.T. monitoring is not working or
supported.
NOTE
When the storage condition is “Bad”, the Event Status – Storage screen displays and you can check
the storage condition for details. Once the “Bad” message displays, replacing the hard disk drive is
recommended, usually within 24 hours.
NOTE
Temperature and S.M.A.R.T. information will be available only for IDE hard disk drives supporting the
SMART (Self-Monitoring Analysis and Reporting Technology) monitoring program.
Î Selecting Close and pressing the button exits the screen.
To Next Page
Loading...
