Operation
91
Siemens Building Technologies
Fire Safety & Security Products 03.2007
9.5 Spot monitoring
You can select the camera you want to display on a Spot Monitor. Press the Spot
button on the front panel or remote control, and select one of four Spot Monitors.
Then, select the camera to be displayed on the Spot Monitor.
Fig. 104 Spot Monitor menu
If you want to display more than one camera on a Spot Monitor, you can display
them sequentially. In the Spot Monitor selection mode, press the Sequence button
on the front panel or remote control, or select Sequence On from the menu to start
displaying cameras sequentially. Press the Sequence button or select Sequence
On again to stop sequencing on the Spot Monitor. Any cameras that are Off, have
lost video or are set to Covert (unless the user has authority to view covert
cameras) will be excluded from the sequence.
Fig. 105 Sequence menu
The Spot Monitor 1 supports multi-view formats and displays live video using the
same settings as the main monitor.
When the Spot Monitor is in the sequence mode, you can set the camera’s display
dwell time. Refer to Section 8: Configuration for details.
To Next Page
Loading...
Need help?
General
