Configuration
44
Siemens Building Technologies
Fire Safety & Security Products 03.2007
5. Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number.
The factory default port settings are:
Remote Admin: 8200
Remote Callback: 8201
Remote Watch: 8016
Remote Search: 10019
NOTE
The system restarts automatically after changing the port settings.
NOTE
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be
connected with the PC running RAS.
NOTE
When changing the port settings, you must change the port settings on the PC running RAS as well.
Refer to the RAS manual for details.
Î Selecting "DHCP" from the Type and highlighting the Save button reads the
current IP address of the DVR configured by DHCP (Dynamic Host
Configuration Protocol) network.
Fig. 37 LAN (DHCP) setup screen
Î Selecting "ADSL (with PPPoE)" allows you to set up the ADSL network.
NOTE
ADSL and modem cannot be configured at the same time. If the DVR is configured by modem, the
ADSL (with PPPoE) will not be selected.
To Next Page
Loading...
Need help?
General
