Siemens SITRANS F Modbus RTU RS 485 - Navigating the Modbus Display Menu

5.2 Navigating the Modbus display menu
1. Power up the device. If the device has been installed correctly a new menu entry has
appeared in the local user interface of the device (between the "Reset mode" and the "Service
mode" menu entries.)
2. Navigate the new menu:
– Press
for two seconds. The display now says "Basic settings"
– Press until you reach the "MODBUS RTU module" menu entry
– Press
– Cycle through the MODBUS RTU settings by pressing .
02'%86578
%DXGUDWH
EDXG
6ODYHDGGU
5HVSRQVHWLPHRXW
V
V
,QWHUIUDPHVSDFH
FKDUV
FKDUV
5HVSRQVHGHOD\
PV
PV
7DJ
)ORZPHWHU
02'%866:YHUVLRQ

02'%86+:YHUVLRQ

&RPPVWDWXV
2.%DG
2N%DG 1RRIPHVVDJHV
UHFHLYHGZLWKRXW&5&
HUURU
)UDPHVWDWXV
3()(
3( 1RRI3DULW\(UURUV
)(  1RRI)UDPLQJHUURUV
3DULW\)UDPLQJ
(YHQVWRSELW
(YHQVWRSELW
2GGVWRSELW
1RQHVWRSELW
1RQHVWRSELW
Figure 5-1 MODBUS USMII Display menu
System integration
5.2 Navigating the Modbus display menu
Modbus RTU RS 485
20 Operating Instructions, 03/2021, A5E00753974-AB