Siemens SITRANS FUP1010 - Page 26

Commissioning
3.3 Setting the Parameters
FUP1010 IP67 Portable Quick Start
24 Operating Instructions, 01/2013, CQO:QSG003 Revision 05
5. The drop down menu lists the following sensor selections:
– 1011 Universal
– 1011HP-T1 - Usable -40 to 120°C, recommended for Ø Temperature <40°C;
Standard.
– 1011HP-T2 - Usable -40 to 120°C, recommended for Ø Temperature >40°C - <80°C;
Named as high temperature.
– 1011HP-T3 - Usable -40 to 120°C, recommended for Ø Temperature >80°C <120°C;
special request.
– 991 Universal
Note
The meter wil
l automatically recommend a sensor depending on the application data
that has been entered.
6. For this example, select the sensor model that appears on the sensor label then press
<ENTER>.



,QVWDOO6HQVRU
6LHPHQV 
 & K D Q Q H O >@$%&
6FUROO/LVWDQGVHOHFWGHVLUHG0RGHO
6H
QVRU0RGHO+37
6HQVRU6L]H '+
6HQVRU0RXQW0RGH5HIOHFW
6SDFLQJ2IIVHW 1RPLQDO
1XPEHU,QGH[

6SDFLQJ0HWKRG 6SDFHU%DU%1
/WQ9DXHLQ 
,QVWDOO&RPSOHWH1R
(PSW\3LSH6HW 07<PDWLF
=HUR)ORZ$GMXVW $FWXDO=HUR
① Select based on type.
② Select based on size.
③ After Sensor is mounted select [Install].
7. To select Sensor Size, press <Right Arrow>. Scroll to select the sensor size that matches
the size indicated on the sensor label. Press <ENTER>.
8. At [Sensor Mount Mode], press the <Right Arrow>. Scroll to select [Reflect] or [Direct]
mount and then press <ENTER>.
9. IMPORTANT: Record Spacing Method and Number Index. This data will be used to
mount the sensors.
10. Sensors can now be mounted. Refer to Sensor Installation (Page 25) mounting
proc
edures and select the mounting mode desired.
11. After sensors are mounted scroll to [Install Complete] and select [Install].