Siemens SITRANS FUP1010 - Setting the Parameters

Commissioning
3.3 Setting the Parameters
FUP1010 IP67 Portable Quick Start
Operating Instructions, 01/2013, CQO:QSG003 Revision 05
17
3.3 Setting the Parameters
Select Language and Units
Note
Before creating a site sele
ct a language and then English or Metric units from the Meter
Facilities menu.
Select a Meter Type
1. Press the <MENU> key and select the Meter Type.
2. Press the Right Arrow> and scroll to [2 Channel Flow]
Note
Select [2 Channel Flow] if measuring two different pipes and [2 Path Flow] if sensors are
mounted on the same pipe.
3. Press <ENTER> to select. Press <Right Arrow> to select meter function. Press
<ENTER>.



6LHPHQV &KDQQHO>@&KDQQHO
6HOHFW0HWHU7\SH
0HWHU7\SH !&KDQQHO)ORZ
0HWHU)DFLOLWLHV 3DWK)ORZ
/DQJXDJH  &K)ORZ
  &K)ORZ
  7KLFNQHVV*DXJH
① Select for measuring two different pipes. (Not available for all models.)
② Select if two sensors are mounted on the same pipe.
③ Select for summing or subtracting flow from two different pipes.
Create a Site
1. Before proceeding make sure that English or Metric units have been selected.
2. At the [Channel Setup] Menu press <Right Arrow> and enter a Site name.
3. Press <ENTER> to create Site name (e.g., ABC). (See figure below.)