Siemens SITRANS FUP1010 - Page 20

Commissioning
3.3 Setting the Parameters
FUP1010 IP67 Portable Quick Start
18 Operating Instructions, 01/2013, CQO:QSG003 Revision 05
Note
To set English or Metric units: In the Meter Type menu, scroll to Meter Facilities Menu.
Press <Right Arrow> and select desired units. Press <ENTER> to select. Press <Left
Arrow> and <Up Arrow> to return to Meter Type menu.
Note
To select letters: Press <Right Arrow> to cursor and then press <Up/Down Arrow> to
select letters and numbers. Press <ENTER> when done.

5LJKW$UURZ(QWHU&UHDWHVDQHZ6LWH
&KDQQHO6HWXS
5HFDOO6LWH6HWXS1RVLWHV
&KDQQHO(QDEOH 1R
6LWH6HFXULW\ 2II
'HOHWH6LWH6HWXS1RVLWHV
6DYH5HQDPH6LWH
&UHDWH1DPH6LWH"
6LHPHQV &KDQQHO>@&KDQQHO
① Insert desired name (8 characters max.)
4. Scroll to [Save/Rename Site]. Press <Right Arrow> then press <ENTER> to save site.
5. Press the <Left Arrow> and return to the main menu.
Select Pipe Class
1. Press the <Right Arrow> to select Pipe Class. Press <Right Arrow> again and scroll to
desired Pipe Class.
2. Press <ENTER> to select.
3LSH'DWD
6LHPHQV &KDQQHO>@$%&
6HOHFW3LSH&ODVV
6
H
OHFW3LSH&ODVV$6$&DUE6WHHO
6HOHFW3LSH6L]H &6
3LSH2'LQ! 
3LSH0DWHULDO
6WHHO
:DOO7KLFNQHVV 
/LQHU0DWHULDO 1RQH
/LQHDU7KLFNQHVV 
3. Pre-programmed Pipe Size and relevant pipe parameters will appear in menu cells. Press
<Right Arrow> and scroll to desired pipe size.