Siemens SITRANS FUP1010 - Table 3- 2 Pipe Configuration Option List Definitions

Commissioning
3.3 Setting the Parameters
FUP1010 IP67 Portable Quick Start
20 Operating Instructions, 01/2013, CQO:QSG003 Revision 05


'HVLJQDWH3LSH6KDSH1HDU6HQVRUV
$SSOLFDWLRQ'DWD
/LTXLG&ODVV :DWHU&)
7HPS5DQJH)WR)
$QRPDO\'LDPV
(OERZ
'EO(OERZ
'EO(OERZ
9DOYH
([SDQGHU
5HGXFHU
1RUP(QWU\
+HDGHU,QOHW
,QWUXVLRQV
3LSH&RQILJ)XOO\'HYHORSHG
6LHPHQV&KDQQHO>@$%&
① Use this menu cell to enter the number of pipe diameters between the upstream
configuration and the Sensor installation.
② Use this menu cell to select the pipe configuration that most accurately represents the
upstream pipe condition.
4. Press the <Left Arrow> and return to the main menu.
Table 3- 2 Pipe Configuration Option List Definitions
Options Definitions
Fully Developed Fully developed flow, as would be expected for very long
straight pipe runs or installation downstream of a flow
condition.
1 Elbow Single 90 degree Elbow upstream of Sensor installation.
Dble Elbow+ Double out-of-plane Elbows upstream of Sensor installation.
Dble Elbow- Double in-plane Elbows upstream of Sensor installation.
Valve Not available at this time.
Expander Pipe expansion upstream of Sensor installation.
Reducer Pipe reduction upstream of Sensor installation.
Norm Entry Not available at this time.
Header Inlet Header or pipe manifold upstream of Sensor installation.
Intrusions Not available at this time.