Siemens SITRANS FUP1010

To Next Page

To Previous Page

Commissioning

3.3 Setting the Parameters

FUP1010 IP67 Portable Quick Start

Operating Instructions, 01/2013, CQO:QSG003 Revision 05

4. Press <ENTER>. Enter dimensions manually if pre-programmed dimensions do not

match application.

Note

The DN sizes listed in the [Select Pipe Size] menu option list are referenced to DIN Table

2448. After selecting pipe size, check pipe OD and wall thickness for correct dimensions.

5. Press the <Left Arrow> and return to the main menu.

Select Liquid Class

1. Press the <Down Arrow> and scroll to [Application Data].

2. Press the <Right Arrow> to select [Liquid Class].

3. Press the <Right Arrow> again and scroll to desired liquid.

4. Press <ENTER> to save selection.



6HOHFW/LTXLG&ODVVIURP/LTXLG7DEOH

/LTXLG&ODVV :DWHU&)

8QL0DVV7DEOH 'LVDEOHG

7HPS5DQJH)WR)

3LSH&RQILJ)XOO\'HYHORSHG

$QRPDO\'LDPV 

$SSOLFDWLRQ'DWD

6LHPHQV&KDQQHO>@$%&

① Select from list.

Select Pipe Configuration

1. Scroll down to [Pipe Config] and press the <Right Arrow>.

2. Select a configuration that approximates the conditions upstream of your Sensor

mounting location. (Refer to the definitions below.)

3. Press <ENTER> to save selection.

Siemens SITRANS FUP1010 - Page 21