Siemens SITRANS FUP1010 - Figure 3-7 Sensor; Figure 3-8 Sensor Installation

Commissioning
3.4 Sensor Installation
FUP1010 IP67 Portable Quick Start
28 Operating Instructions, 01/2013, CQO:QSG003 Revision 05
10. Take either sensor and apply a continuous lengthwise 3mm (1/8-inch) bead of coupling
compound across the center of the sensor emitting surface.






① F-Connector ④ Front Face
② Angled Edge ⑤ Emitting Surface
③ Sensor ⑥ Coupling Compound
Figure 3-7 Sensor











5()
① ⑥ Front View Mounting Strap
② Spring Clip (Not present on some
models)
⑦ Note: Operational 2nd Mounting Strap
shown. Larger pipes over 76cm (30 inches)
may need an additional support.
③ Sensor Clamping Screw ⑧ Spacer Bar Platform and Clamping Screw
④ Spacer Bar ⑨ Spacer Bar Reference Hole
⑤ 1012 Series Mounting Frame ⑩ Orientation for Single Beam Sensor at 9
o'clock position
⑪ Orientation for Dual Beam Sensor at 10 & 2
o'clock positions
Figure 3-8 Sensor Installation