Siemens SITRANS FX330 - Turning the connection housing

3 INSTALLATION
40
SITRANS FX330
www.siemens.com/flow 08/2022 - A5E36751269-AG EN
3.10 Turning the connection housing
• Loosen the M4 Allen screw ① on the side of the connection housing.
• Rotate the connection housing to the desired position (0...<360°).
• Tighten the M4
Allen screw ① again.
DANGER!
All work on the device electronics may only be carried out by appropriately trained personnel.
The regional occupational health and safety directives must always be observed.
Figure 3-19: Turning the connection housing
1 M4 Allen screw on connection housing