Siemens SITRANS FX330 - Turning the display

INSTALLATION 3
41
SITRANS FX330
www.siemens.com/flow08/2022 - A5E36751269-AG EN
3.11 Turning the display
Turn the display as follows:
• Disconnect the power supply from the measuring device.
• Unscrew the housing cover with the key ① .
• Please use the handle to pull out the display module.
• First put the handle on side "a" and then on side "b" of the display,
and then pull out the
display ② carefully. Turn it into the favoured position ③ .
• Disconnect the display from the handle first on side "a" and then on side "b".
• Press the display onto the spacer pins ④ , until it clicks.
• Turn the cover with gasket ⑤ back onto the housing and tighten it by hand.
DANGER!
All work on the device electronics may only be carried out by appropriately trained personnel.
The regional occupational health and safety directives must always be observed.
INFORMATION!
If the measuring device is installed in a vertical pipe, you will have to turn the display by 90°; if
in
stalled below a pipe, turn 180°.
INFORMATION!
The display can be turned in increments of 90° to four positions.
Figure 3-20: Turning the display
INFORMATION!
Before closing the housing cover refer to Maintaining the O-rings on page 101 .