Siemens SITRANS FX330 - Page 79

OPERATION 6
79
SITRANS FX330
www.siemens.com/flow08/2022 - A5E36751269-AG EN
A11.6 Application Assistant - FAD
.7 Gas
.7.1 Relative Humidity If fluid = "Wet Gas", enter 0…100%.
.8 Operating Values Same options as in A11.1.4.
.9 Normal Values Default settings according to order specification or DIN.
.9.1 Norm. Temperature Confirm default setting or define in selected temperature unit.
.9.2 Norm. Pressure Confirm default setting or define in selected pressure unit.
.9.3 Norm. Density Confirm default setting or define in selected density unit.
.10 Current Output Same options as in A11.1.5.
.11 Binary Output Same options as in A11.1.6.
.12 Pulse Output Same options as in A11.1.7.
.13 Frequency Output Same options as in A11.1.8.
.14 Status Output Same options as in A11.1.9.
.15 Limit Switch Same options as in A11.1.10.
.16 Flow Totalizer Same options as in A11.1.11.
.17 1. Meas. Page Same options as in A11.1.13.
.18 2. Meas. Page Same options as in A11.1.14.
Table 6-26: A11.5 Application Assistant - Gas
Function Setting / Description
This application assistant is available if meter type is set to "Heat & Dens. & FAD" (refer to "C6.3 Extras").
.1
.2 Units
.2.1 Volume Flow
Select unit (default: according to order specification or m
3
/h).
.2.2 Norm. Vol. Flow
Select unit (default: according to order specification or Nm
3
/h).
.2.3 Volume
Select unit (default: according to order specification or m
3
).
.2.4 Norm. Volume
Select unit (default: according to order specification or Nm
3
).
.2.5 Temperature Select unit (default: according to order specification or °C).
.2.6 Pressure Select unit (default: according to order specification or bar).
.2.7 Density
Select unit (default: according to order specification or kg/m
3
).
.3 Process
.3.1 Fluid Select "Gas".
.3.2 Medium Select "Air".
.3.3 Time Constant 0...100 s
.3.4 Low Flow Cutoff Enter low flow cutoff point in current volume flow unit.
.4 Current Input Same options as in A11.3.4.
.5.1 Temp. Source1 Internal / External / External HART / Not Available
.5.2 Temp. Source2 Internal / External / External HART / Not Available
Temperature source 1 and 2 must be different.
.6 Gas
.6.1 Inlet Temperature Enter temperature on inlet side in selected unit.
.6.2 Atm. Pressure Enter current ambient pressure in selected unit.
Function Setting / Description