Page 64 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL A5E33701270
mmmmm
Operation - AMS
Step 3 – Shape
1. Select the Primary Measuring Device (PMD). If selection is any value except Off,
click into the field below, to update the screen with the various PMD dimensions
requiring entry. For example, if PMD selected is Palmer Bowlus Flume, a value must
be entered for Maximum Flume Width, hmax.
2. Enter all required values.
3. Click on Next.
Step 4 – Ranges
1. Change units if desired (in meters by default).
2. Set High and Low Calibration points.
3. Set Response Rate, Volume Units, and Maximum Volume.
4. Select a Method of Flow Calculation, and set Maximum Head, Flowrate Units,
Maximum Flow, Flowrate Decimal, and Low Flow Cutoff.
5. Click on Next.
6. If PMD selected is Universal Head Flow, the Characteristic curve appears.
To Next Page
Loading...
