EasyManuals Logo

Siemens ST-H Operation Manual

Siemens ST-H
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
7ML19985QK82 ST-H Transducer – OPERATION MANUAL Page EN-3
mmmmm
English
Introduction
The ST-H transducer operates with Siemens Milltronics
ultrasonic level monitoring products.
The transducer converts the electrical energy of the transmit
pulse from the transceiver into acoustical energy. It then
converts the acoustical energy of the echo back into
electrical energy for the controller.
The transducer face emits acoustical energy that radiates
outward, decreasing in amplitude at a rate inversely
proportional to the square of the distance. Maximum power
radiates perpendicularly from the transducer face on the
axis of transmission. Where power is reduced by half (– 3
dB), a conical boundary centered around the axis of
transmission defines the sound beam, the diameter of which
is the beam angle.
The ST-H transducers have an integrated temperature sensor that reports the air temperature
at the transducer to the controller.
General Guidelines
WARNING: Materials of construction are chosen based on their chemical
compatibility (or inertness) for general purposes. For exposure to specific
environments, check with chemical compatibility charts before installing.
Note: This product is intended for use in industrial areas. Operation of this equipment in a
residential area may cause interference to several frequency based communications.
transducer
transducer face
–3db
boundary
axis of
transmission,
perpendicular to
transducer face

Table of Contents

Other manuals for Siemens ST-H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens ST-H and is the answer not in the manual?

Siemens ST-H Specifications

General IconGeneral
BrandSiemens
ModelST-H
CategoryTransducer
LanguageEnglish

Related product manuals