What does 'FAULT port RS232' mean on Siemens Measuring Instruments and how can I fix it?
If your Siemens Measuring Instruments display 'FAULT port RS232', it indicates a communication problem in the serial ports. Reset the system. If the fault persists or occurs frequently, replace K3X...
What does 'Error:Checksum fault in area: ###' mean on Siemens Measuring Instruments and how to resolve it?
If your Siemens Measuring Instruments display 'Error:Checksum fault in area: ###', it indicates a hardware problem. To resolve this, unpower the system and then re-power it. If the message reappears, replace the main board K3X...
What does 'Error:Mod.###,Id.##,Par1.#### Par2.####' mean on Siemens Measuring Instruments and how to resolve it?
If your Siemens Measuring Instruments display 'Error:Mod.###,Id.##,Par1.#### Par2.####', it indicates a software problem. To resolve this, unpower the system and then re-power it. If the message reappears, replace the main board K3X...
What does 'Error:Code execution error, Flag ###' mean on Siemens Measuring Instruments and how to resolve it?
If your Siemens Measuring Instruments display 'Error:Code execution error, Flag ###', it indicates a software problem. To resolve this, unpower the system and then re-power it. If the message reappears, replace the main board K3X...
What does 'Door OPEN on FSD' mean on Siemens Measuring Instruments and how to resolve it?
If your Siemens Measuring Instruments display 'Door OPEN on FSD', it means the door is open at the FSD after the fire alarm is reset (only with VdS card). Check the FSD device.
What does 'BREAK > line ##' mean on Siemens Measuring Instruments and what should I do?
If your Siemens Measuring Instruments display 'BREAK > line ##', it indicates a break in the detector loop. Check the cable connection.
What does 'External power supply fault' mean on Siemens Measuring Instruments and how can I fix it?
If your Siemens Measuring Instruments display 'External power supply fault', it indicates a fault on the power supply input ’K50’. Check input ’K50’ on K3X...
What does 'Missing telegram at LON dev. ##' mean on Siemens Measuring Instruments and how to fix it?
If your Siemens Measuring Instruments display 'Missing telegram at LON dev. ##', it means a telegram is missing at the LON device. Press ’Acknowledge’ then ’Reset’ on the operating panel.
What to do if Siemens Measuring Instruments display 'RESTART due to power down'?
If your Siemens Measuring Instruments display 'RESTART due to power down', it means the system stopped because of disconnection by ‘low discharge protection’ (mains failure and battery
What to do if Siemens Measuring Instruments show '24V supply too low'?
If your Siemens Measuring Instruments display '24V supply too low', it's because the battery voltage is too low and the mains are disconnected. To solve this, restore the mains voltage and then reset the system.
General| Measurement Principle | Coriolis |
|---|---|
| Protection Class | IP67 |
| Material | Stainless steel |
| Communication | HART, PROFIBUS PA |
| Outputs | 4-20 mA, pulse/frequency |
| Display | LCD |
| Output Signal | 4-20 mA, pulse/frequency |
| Process Temperature | -50 to +150 °C (-58 to +302 °F) |
To Next Page
