e1973c-16
02.2004
52
Fire & Security Products
Siemens Building Technologies Group
Set time and date
i
Changeover summertime to wintertime: manually automatically
Purpuse and Principle
Time and date are set by the service engineer when the system is put into service. Under normal
conditions there is no need to correct time and date.
The changeover from summertime to wintertime and vice versa is performed automatically for
Central European Time. Central European Time is valid for Western Europe, most of Eastern
Europe an parts of Russia. The switchover from summertime to wintertime is performed at the
last sunday in March, vise versa at the last sunday in October. Differing automatic switching ti-
mes are not possible.
Only due to an electronical distortion or a complete power failure (mains and battery interrupted)
the system sets time and date to “default”.
Set time and date
Log in with at least ”access level 2”.
1. Press
St
.
Display shows
2. Enter the password and press
ok
.
Display shows
3. Select option 4. 1. 2.
Display shows
4. Enter the current time and press
ok
.
Display shows
5. Enter the current date and press
ok
.
Time and date are set to the current va-
lues.
Display shows
6. Use
St
to terminate the time and date setting.
START system operating
> enter password?
hm /Stop: end operating
SELECT: 1. ENabling
(main menu) 2. DISabling
3. INFO polling
4. other functions
set TIME: ##:##:##
> new time: hour.min.sec.?
hm: back to menu Stop: end operating
set DATE: ##.##.##
> new date: day.mon.year?
hm: back to menu Stop: end operating
FUNCTIONS: 1. switching alarm org.
(4.1) 2. set time / date
To Next Page
Loading...
