EDM eco
Operating instructions Unit settings
TU00-1404-0311020 © Siemens VDO Trading GmbH 43
Edition 11/2003
English
Changing the distance travelled calibration values
If the distance travelled gauge on the consumption display unit
• indicates that the total number of kilometres travelled is less than that shown on the vehicle
instrumentation, you must increase the distance travelled calibration value.
• indicates that the total number of kilometres travelled is more than that shown on the vehicle
instrumentation, you must reduce the distance travelled calibration value.
If several vehicles of the same type are fitted with the same type of tyres, a calculated calibration
value can be used for all these vehicles
5 After you have completed all entries, press the key until you return to the
normal display mode.
1 Press the key and the key at the same time to switch to the unit
settings.
The first menu item 86(U6HW83 will be displayed automatically.
2 Select the 6\6W(6HW83>&$/6\6W(>G,V7&$/>&RQ6WG,6W
(-> 27) menu item (-> 31).
If PIN protection has already been activated, you will automatically be asked
to enter the system PIN number in the place indicated (-> 24).
To Next Page
Loading...
