Sigicom INFRA C12 - Table of Contents

To Next Page

To Previous Page

Table of Contents

1. Introduction ......................................................................................... 9

1.1. INFRA Monitoring System ....................................................... 9

1.2. INFRA C12 Triaxial Vibration Monitor ................................... 9

1.3. Automatic Data Transfer through GSM/Internet .................... 10

1.4. Unpacking and Parts Identification ......................................... 10

2. The Enclosure ................................................................................... 11

2.1. Buttons .................................................................................... 11

2.2. LEDs ....................................................................................... 12

2.2.1. Comm LED (yellow/orange) .............................................. 12

2.2.2. Check LED (white or red) .................................................. 13

2.2.3. Reg LED (green) ................................................................. 13

2.3. Antennas .................................................................................. 14

2.4. Battery Module ........................................................................ 14

2.5. Solar Panel .............................................................................. 15

2.6. External Power Port ................................................................ 15

2.7. USB Connector (Mini-B Type) ............................................... 16

2.8. CompactFlash .......................................................................... 16

2.9. SIM Card ................................................................................. 18

3. Measuring Parts of the System ......................................................... 19

3.1. Measuring Hardware ............................................................... 19

3.1.1. Vibration Sensor ................................................................. 19

3.1.2. Analog Electronics .............................................................. 19

3.1.3. Analog-Digital Conversion ................................................. 19

3.1.4. Digital Signal Processing .................................................... 19

3.2. Measuring Logic ..................................................................... 20

3.2.1. Measurement Standards ...................................................... 20

3.2.2. Interval Measurements ........................................................ 20

3.2.3. Frequency Detection, Weighting and Trigger filter ............ 21

3.2.4. Transient Recording ............................................................ 22

3.2.5. Overload Handling .............................................................. 22

3.3. File Types ................................................................................ 23

3.3.1. Event Files (.log) ................................................................. 24

3.3.2. Interval Files (.interval) ...................................................... 24

3.3.3. Transient Files (.transient) .................................................. 25

3.4. Data Storage on CompactFlash ............................................... 26

4. Configuration and Installation .......................................................... 27

4.1. Configurations and Settings .................................................... 27

4.1.1. Data Server Connection Schedule ...................................... 27