SDS Series
22
SDS SERIES MENU SHORT-CUTS:
View Program Status:
Note: A = Active, P = Paused, R = Rained-Off, F = Frost Program Setup + Enabled
From the current Time
and Date display press
P1 2 3 4 5 6 7 8
A A P P R R f f
Quick Start Programming
f = Frost Program Setup + Disabled
View Last Program Start/Stop Details:
From the current Time and Date display
press desired program number. ie:
P1 Last Stopped
00:01:00—12/03
When Entering a Program—Enable/Disable Start Times:
From the current Time and Date display
press desired active program number. ie:
P1 N M49B00 100%
S01 00:19:30
Note: P1 = Program 1, N = Program type (Normal), M49B00 = Master Pump 49, Booster Pump 00
(Off), 100% = Program set percentage, S01 = Active station, 00:19:30 = Station countdown in hh/
mm/ss.
(cont) View Currently Active Valves:
From the program infor-
mation screen shown above:
P1 N M49B00 100%
S01 00:19:30
V 01 03 07 49
View Details of Active Program:
Enter a Program as usual before
reaching the Start Time display:
<P1 Start Time1>
NONE
<P1 Start Time1>
06:00:00 AM
Skip Forward/Back Stations while Manually Testing:
While manually running stations, key
the desired station number, then press:
Man.Stns Run
Stn No.1( 09:30)
Station count-
down displayed
(cont) From Another Screen, Return to Active Manual Station Display:
From the current Time
and Date display press
Man.Stns Run
Stn No.1( 09:30)
From here, stations can be
skipped forward/back, as above
View Fault (When Red LED is Showing):
From the current Time
and Date display press
To clear
fault press:
To Switch Pressure Transducer from Digital to Analogue (Transducer):
Navigate to INPUTS
menu within controller:
Pressure Sensor
Digital Inputs
Pressure Sensor
L000 S000 H000
Note: L = Low. S = Skip, H = High
To Next Page
Loading...