Settings
32 / 60
Parameter Values Default value
«Operating hrs.» xxx
View the operating hours since initial commissioning at the factory.
«Version Main» -
Software version of the main controller.
«Version Sensor» -
Software version of the sensor controller.
«Version Comm» -
Software version of the communication controller.
«Version Web» -
Software version of the interface for the Sigrist-Webinterface.
«Update firmware» [Check online]
[Select file...]
[Upload & update]
Check online: With an Internet connection, it is possible to check whether new software is available. A valid
DNS server address must be available in the communication module.
Select file: Select new firmware.
Upload & update: Upload firmware to sensor.
«Reset to factory settings» [Load...]
Restore factory settings.
«Support information» [Download]
Generate zip file with current data and configuration values for support. The generation takes approx. 30 sec-
onds.
System Info\ Backup & Restore
Parameter Values Default value
«Backup» [Create New]
Save configuration to measuring device. For identification, enter a description according to the software text.
«Restore» [Restore...]
[Download...]
[Delete...]
Select one of the displayed configurations:
Restore: Load selected version. NOTICE!
The current configuration is overwritten and cannot be restored.
Download: Download selected configuration.
Delete: Delete selected configuration.
«Restore challenge» xxxx
Individual code for loading the factory configuration.
To Next Page
Loading...
Need help?
General
