SIGRIST TurBiScat PM 40 User Manual

Troubleshooting
53 / 60
Code Message Description Possible causes
E20 LIGHT SOURCE 2 Detector for monitoring the light
source is not receiving light from the
corresponding light source.
l Defective light source
Contact service technician.
11.5 Prio fault messages
The following Prio fault messages may be displayed during operation.
Code Message Description Possible causes
P1 DEFAULT VALUES Default values have been loaded l Defective electronics
Contact service technician
P3 CRC EXPERTS An error was detected during the
check of the expert data.
l Defective electronics
Contact service engineer
P4 CRC USER An error was detected when
checking the user data
l Defective electronics
Contact service engineer
P5 CRC DISPLAY An error was detected when
checking the display data
l Defective electronics
Contact service engineer

SIGRIST TurBiScat PM 40 Specifications

General

Brand	SIGRIST
Model	TurBiScat PM 40
Category	Measuring Instruments
Language	English